NeilMed Sinus Rinse Starter Kit Bottle & 10 Sachets

Product Details

Sinus Rinse is a soothing, large volume and low pressure system for therapeutic and preventive saline nasal irrigation, moisturization and daily nasal hygiene.

Positive pressure flow mobilises and removes thick mucus and crusts.

Features and Benefits

– Soothing

– Not burning or stinging

– Preservative, iodine & latex free

– Relieves allergies, sinus stuffiness and symptoms from cold and flu

– Suitable for use during pregnancy

How to use

Step 1: Please wash your hands. Fill the clean bottle with the designated volume of lukewarm distilled, filtered or previously boiled water. You may warm the water in a microwave in increments of 5 to 10 seconds to avoid overheating the water, damaging the device or scalding your nasal passage.

Step 2: Cut the SINUS RINSE mixture packet at the corner and pour its contents into the bottle. Tighten the cap and tube on the bottle securely. Place one finger over the tip of the cap and shake the bottle gently to dissolve the mixture.

Step 3: Standing in front of a sink, bend forward to your comfort level and tilt your head down. Keeping your mouth open, without holding your breath, place the cap snugly against your nasal passage. SQUEEZE BOTTLE GENTLY until the solution starts draining from the OPPOSITE nasal passage. Some may drain from your mouth. For a proper rinse, keep squeezing the bottle GENTLY until at least 1/4 to 1/2 (60 mL to 120 mL or 2 to 4 fl oz) of the bottle is used. Do not swallow the solution.

Step 4: Blow your nose very gently, without pinching nose completely to avoid pressure on eardrums. If tolerable, sniff in gently any residual solution remaining in the nasal passage once or twice, because this may clean out the posterior nasopharyngeal area, which is the area at the back of your nasal passage. At times, some solution will reach the back of your throat, so please spit it out. To help drain any residual solution, blow your nose gently while tilting your head forward and to the opposite side of the nasal passage you just rinsed.

Step 5: Now repeat steps 3 and 4 for your other nasal passage.

Step 6: Clean the bottle and cap (see directions below). Air dry the SINUS RINSE bottle, cap, and tube on a clean paper towel or use NeilMed NasaDOCK or NasaDOCK plus (sold separately) to store the bottle, cap and tube.

Ingredients

Sodium Bicarbonate, Sodium Chloride USP. Bottle made up of Low-density polyethylene. Black Cap – Polypropylene plastic. Silicone Tube – Silicone.

Warnings

Rinsing your nasal passages with only plain water will result in a severe buring sensation. Use lukewarm distilled, filtered or previously boiled water, properly mixed with NeilMed Sinus Rinse packets. Do not rinse if nasal passages are completely blocked or if you have an ear infection or blocked ears. Please retain the enclosed brochure in pack for instructions & other important information. Keep out of reach of children.